Example for SCSI, SATA, and ATA Controllers:

In this example, temperature probe 3 resides in the enclosure attached to connector 2 on controller 1. To set the temperature probe thresholds to 10 and 40° Celsius, enter:

omconfig storage enclosure action=settempprobes controller=1 enclosure=2 index=3 minwarn=10 maxwarn=40

omconfig Reset Temperature Probe Thresholds

Use the following omconfig command syntax to reset the minimum and maximum warning temperature thresholds back to their default values.

NOTE: This command is not supported on SAS controllers.

Complete Syntax

omconfig storage enclosure action=resettempprobes controller=id enclosure=<ENCLOSUREID> index=id

where id is the controller ID and the temperature probe ID. The <ENCLOSUREID> variable specifies the enclosure.

Example Syntax

For example, you may want to reset the thresholds for temperature probe 3 to the default values.

Example for SCSI, SATA, and ATA Controllers:

In this example, temperature probe 3 resides in the enclosure attached to connector 2 on controller 1. To reset the thresholds for temperature probe 3 to the default values, enter:

omconfig storage enclosure action=resettempprobes controller=1 enclosure=2 index=3

omconfig Set All Temperature Probe Thresholds

Use the following omconfig command syntax to set the minimum and maximum warning temperature thresholds for all temperature probes in the enclosure.

NOTE: This command is not supported on SCSI RAID controllers.

Complete Syntax

omconfig storage enclosure action=setalltempprobes controller=id enclosure=<ENCLOSUREID> minwarn=n maxwarn=n

where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.

Using the Storage Management Service

183

Page 183
Image 183
Dell Command Line Interface Omconfig Reset Temperature Probe Thresholds, Omconfig Set All Temperature Probe Thresholds