Dell Command Line Interface Command User Level Privilege Required Frontpanel, Components, Memory

Table 3-1. omreport Command Level 1, Level 2, and Level 3 (continued)

Command	Command	Command	User	Use
level 1	level 2	level 3	privilege
			required
		frontpanel	U, P, A	Shows whether the front panel button settings,
				such as for the Power button and/or Nonmasking
				Interrupt (NMI) button (if present on the
				system), are enabled or disabled.
		fru	U, P, A	Shows the Field Replaceable Unit (FRU)
				information.
		info	U, P, A	Shows a status summary for main system chassis
				components.
		intrusion	U, P, A	Shows the status of the system’s intrusion
				sensor(s).
		leds	U, P, A	Shows the properties you have set for LEDs to
				flash under various alert conditions.
		memory	U, P, A	Shows properties of your system's memory arrays.
		nics	U, P, A	Shows number of NICs installed in your system,
				NIC vendor, NIC description, IP address, and
				connection status.
		ports	U, P, A	Shows properties for your system’s parallel and
				serial ports, such as I/O address, IRQ level,
				connector type, and maximum speed.
		processors	U, P, A	Shows properties of your system’s processors,
				including speed, manufacturer, and
				processor family.
		pwrsupplies	U, P, A	Shows properties of power supplies.
		remoteaccess	U, P, A	Shows general information on remote access.
		slots	U, P, A	Shows properties of your system’s expansion slots
				and other slot types.
		temps	U, P, A	Shows the status and thresholds for the system
				temperature sensors.
		volts	U, P, A	Shows the status and thresholds for the system
				voltage sensors.
	storage		U, P, A	See "Using the Storage Management Service."
	system		U, P, A	Shows a high-level summary of system
				components.

omreport: Viewing System Status Using the Instrumentation Service

23