Emerson E2 operation manual Logging On and Access Levels, CX Home Screen

Power Monitoring Section

In the lowest left-hand corner of the BX Home screen is the power monitoring section, containing active KW and average power information.

Light Schedules Section

In the center of the BX Home screen is ON and OFF status information for light schedules.

Air Handling Units Section

Located at the top right-hand corner of the BX Home screen, the AHU section shows the number of AHUs, tem- perature, state, and ASP information for each.

Zones Section

Directly below the AHU section is the Zones section, which shows the number of zones, temperature, whether or not the application is in occupied mode, CSP and HSP.

Sensor Control Section

Sensor Control is at the bottom right-hand corner of the BX Home screen and contains analog and digital sen- sors, value, command, and status information.

12.1.3 CX Home Screen

		7
		8
	10	9
Lighting	6 Network Information
HVAC Control	7	Anti-Sweat
Refrigeration	8	Controller Information
Demand Control	9	Time Schedules
5 Advisory Information	10 Sensor Control

Figure 12-3- CX Home Screen

Lighting Control Section

The lower left-hand corner of the screen shows name and bypass output for the lighting circuits.

HVAC Control Section

The top left-hand corner of the screen shows whether the fans are ON or OFF, state, and dehumidification status of the first two air handlers in the sequence.

Refrigeration Control Section

The top center of the screen shows the name, state, and

current temperature of standard circuits.

Demand Control Section

The top right-hand corner of the screen shows the sta- tus of the Demand Control application.

Anti-Sweat Control Section

The middle right-hand section of the screen shows name and percent ON information for each anti-sweat application.

Sensor Control Section

The bottom center section of the screen shows both analog and digital sensor control, name, and command output.

Time Schedules Section

The lower right-hand section of the screen shows the name and current status of time schedules.

12.2Logging On and Access Levels

An E2 may be programmed with up to 25 different

users. A user basically consists of a username, a password, and an access level. Whenever a username and password are entered during login, the E2 searches the user records for the username and password. If found, the E2 will log the user in at the access level configured for the user in the user records.

The access level determines how many of the E2’s fea- tures the user may use. The E2 uses four access levels, one being the lowest, and four being the highest. Table 12-1gives a description of each level and the capabilities they have access to.

Level 1	Read-only access. Users may generally
	only view status screens, setpoints, and
	some system settings.
Level 2	Setpoint and bypass access. Users may
	perform all the tasks a level 1 user may,
	and they may also change control setpoints
	and bypass some devices.
Level 3	Configuration and override access. Users
	may perform all the tasks a level 2 user
	may, and they may also override system
	settings, create new cells, and program
	new applications.
Level 4	System Administrator access. All E2 func-
	tions are accessible by a level 4 user.

Table 12-1- User Access Levels

12-2 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013