Emerson E2 operation manual CCB Case Controllers, to Valve Connection Information, ESR8 Boards Dis

Wire on Valve Cable
335-3260				Sporlan
Pin #	Color	Emerson	Emerson	SEI&CDS
		Flow Con-	Flow Con-
		trols ESR	trols ESV
1	Red	Red	Blue	Red
2	Black	Blue	Red	Green
3	Blue	Black	Black	Black
4	Green	White	White	White
5	White		Yellow
6	Brown

Table 9-5- 335-3260 to Valve Connection Information

9.4CCB Case Controllers

For information on retrofitting E2s in RMCC stores with CCBs, refer to Technical Bulletin #026-4119. For other information about CCB wiring, hand-held terminal programming and operation, refer to the CCB Installation Manual (P/N 026-1110).

9.5ESR8 and MultiFlex ESR Valve Output Wiring

ESR8 Boards (Discontinued)

For ESR8 boards, the stepper valves are wired to the board by connecting the four-conductor wire from the stepper valve to a connector plug and then plugging in to

one of eight jacks along the top of the board Figure 9-19.Use the cable harnesses supplied with the valves or use Belden #9418 four-conductor 18AWG wire.

NOTE: A wire run may not be longer than 150 ft. using Belden #9418.

If the stepper valves have block-style connectors, cut the ends off and attach the terminal plugs supplied with the ESR8 to the wire ends.

							Emerson
WHITE					R		Flow
			E
BLACK		P				E	Controls ESR
		P
				V
BLUE	TE L
	S	A
RED		V
TOP OF BOARD
Pin 1
Figure 9-19- ESR8 Valve Wiring

NOTE: For Sporlan CDS, wire the same as Emerson Flow Controls ESR, but use green wire in place of blue wire.

MultiFlex ESR Board

The stepper valves are wired to the board by connect- ing the stepper valve harness to one of the eight screw ter- minal connectors along the top of the board (Figure 9-20)and matching the wire colors to the legend on the connec- tors. Use the cable and cable harnesses that are supplied with the valves.

Stepper Valve

Harness

BLUE

BLACK

REDMatch wire colors to

WHITE silk screen legend on board terminals

MultiFlex ESR Board w/ Eight	ECT Flow
Screw Terminal Connectors	Stepper Valve
(P/N 810-3199)

Figure 9-20- ECT Flow Valve and MFlex ESR Board Wiring

9-18 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013