Emerson E2 operation manual Figured as an analog input

SYMPTOM	POSSIBLE PROBLEM	SOLUTION
Dehumidification Problems	Number of stages are not set up	From the Home screen, press
	or set up incorrectly.	 (AHU),  (SETUP).
		Move cursor to C9 (Dehum) to
		check Dehum Stages.
	Dehumidifier source not set up.	From the same screen, verify
		what the sensor source is.
	Temperature setting for	From the same screen, check the
	DEHUM OCC or DEHUM	minimum temperature setting.
	UOC is set too high.
Lighting Control Problems	Lights will not come on.	Make sure you have a Time
		Schedule set up. A Time Sched-
		ule is not Lighting Control. You
		can use the same Time Schedule
		for several Lighting Controls.
		Set up the Time Schedule first
		and then assign it to a Lighting
		Control.
		Set up a Time Schedule and got
		to Lighting Control. Choose the
		desired application and press
		(SETUP). Move the cursor
		to C7 (Inputs) and highlight the
		Board field. Press  (LOOK
		UP), choose the input device and
		press . Highlight the Point
		field and press  (LOOK
		UP). Select the type of schedule
		and press .
		Make sure Lighting Control out-
		put is assigned.
Lights Will Not Come On With	Photocell is not recognized by	Make sure the photocell is con-
The Photocell	controller.	figured as an analog input.
		Verify that the type of light sen-
		sor is correct.
		If using a light level sensor from
		another E2 controller, set it up
		on the controller it is associated
		with in the Global Data section.

F-8 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013