Emerson operation manual 12 E2 RX/BX/CX I&O Manual Rev 4 5-JAN-2013

Alarm Name	Default	Definition
	Priority
Point Log Cleared-Stamps Ahead	50	After a power failure or reset, E2 tried to recover log
		data from its memory, but the log data was corrupted.
		E2 cleared all data from its point logs and started
		over.
Point Log Stuck-No Memory	15	A Point Log is unable to save new values because
		there is not enough memory.
Point Logs Not Restored	15	The point logs stored in memory were not restored
		after the last reset or upgrade.
Pressure Table Lost-Being Rblt	50	A Suction Group’s internal list of possible compres-
		sor combinations became temporarily invalid, requir-
		ing a rebuild.
Product Temp Hi Limit Exceeded	User	A product temperature probe in a standard or case-
		controlled circuit has measured a product tempera-
		ture above the low limit setpoint.
Product Temp Lo Limit Exceeded	User	A product temperature probe in a standard or case-
		controlled circuit has measured a product tempera-
		ture below the low limit setpoint.
Program ID mismatch	20	Open Echelon controller Program ID does not match
		expected Program ID.
Proof Fail	User	A proof checking device is registering a failure in one
		of the Application’s control devices.
Proof Failure Occurred	User	A proof checking device is registering a failure in one
		of the Application’s control devices.
Proof Reset-Stage In retry	50	Due to a FAIL signal from a proof checking device,
		the E2 is attempting to reset the proof failure.
Rack Failure Occurred	User	A Suction Group application is registering a total
		rack failure.
REFR Phase Loss	User	A phase loss device connected to Global Data has
		switched ON to shut down all refrigeration systems.
REFR Shutdown	User	A Global Data application’s REFR Shutdown input
		has turned ON to shut down all suction groups, con-
		densers, and circuits.
Relativ Adv: No Active Setpt	99	An application that is supposed to be generating an
		alarm for a specified input has no active setpoint to
		use for alarming. This usually occurs when alarm set-
		points are supplied by other applications or inputs,
		and the application or input fails.
Resize bad! Logging Terminated	10	The number of samples was changed in a log group
		and the resizing of the file storing data was not suc-
		cessful. Check memory.
Runtime Log Stuck-No Memory	15	A Runtime Log is unable to save new data because
		there is not enough memory.
Runtime Logs Not Restored	15	The runtime logs stored in memory were not restored
		after the last reset or upgrade.

C-12 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013