Emerson E2 Components, Closed Network Layout Open Network Layout, Powering Echelon Devices

		6.4.3.1 Add and Connect a BACnet Device		6-14
7 E2 ETHERNET PEER COMMUNICATIONS				7-1
7.1	ETHERNET IP CONFIGURATIONS			7-1
7.2	HARDWARE SPECIFICATIONS			7-1
7.2.1		Components		7-1
7.3	SOFTWARE SPECIFICATIONS			7-2
7.4	ETHERNET NETWORK LAYOUTS			7-2
7.4.1		Closed Network Layout		7-2
7.4.2		Open Network Layout		7-3
7.5	SOFTWARE SETUP			7-3
7.6	TROUBLESHOOTING			7-4
8 ECHELON NETWORK AND HARDWARE SETUP				8-1
8.1	OVERVIEW		.................................................................................................................................................................	8-1
8.2	WIRING TYPE			8-1
8.3	ECHELON NETWORK STRUCTURING (DAISY-CHAINS)			8-1
8.3.1 Maximum Number of Echelon Devices				8-2
8.4	DEVICE TERMINATION			8-2
8.4.1 Using a Termination Block (P/N 535-2715) to Terminate a Daisy Chain				8-3
8.5	WIRE RESTRICTIONS			8-3
8.6	INSTALLING ECHELON DEVICES			8-3
8.6.1		Powering Echelon Devices		8-3
8.7	LEDS			8-4
8.8	OPEN ECHELON DEVICE CONNECTIVITY			8-4
8.8.1		Configuring Echelon Devices		8-4
		8.8.1.1	Troubleshooting	8-5
9 INPUT AND OUTPUT SETUP				9-1
9.1	THE 16AI, 8IO, AND MULTIFLEX INPUTS			9-1
9.1.1 Connecting Sensors to Input Boards				9-1
		9.1.1.1	Wiring	9-1
		9.1.1.2	Sensor Wiring Types	9-1
		9.1.1.3 Input Type Dip Switches		9-1
9.1.2		Power Connection		9-2
9.1.3 Input Setup in E2				9-6
		9.1.3.1 Configuring a Point from the Input Definitions/Status Screen		9-6
		9.1.3.2 Using the Input Definitions/Status Screen		9-7
		9.1.3.3 Setting Up Analog Inputs		9-7
		9.1.3.4 Setting Up Digital Inputs		9-9
9.2	THE 8RO, 8IO, AND MULTIFLEX OUTPUTS			9-10
9.2.1 Wiring Form C Contacts				9-10
9.2.2		MultiFlex Relay Outputs		9-10
9.2.3 Setting the Fail-Safe Dip Switch				9-11
9.2.4 Relay Output Test Mode				9-11
9.2.5 Wiring Outputs to Points				9-12
9.2.6		The Output LED		9-12
9.2.7 Output Setup in E2				9-12
		9.2.7.1 Configuring a Point from the Output Definitions/Status Screen		9-12
		9.2.7.2 Using the Output Definitions/Status Screen		9-13
		9.2.7.3 Setting Up Digital Outputs		9-13
		9.2.7.4 Setting Up Analog Outputs		9-14
9.3	CC-100 CASE CONTROLLERS			9-16
9.3.1		Inputs		9-16
9.3.2		Power Module Wiring		9-17

viii • Table of Contents 026-1614 Rev 4 5-JAN-2013