Emerson E2 operation manual Ram

Alarm Name	Default	Definition
	Priority
RX/BX Firmware Update Failed	20	The E2’s firmware update was not successful.
RX/BX Firmware Was Updated	50	The E2’s firmware was successfully updated.
Smoke Detected	30	A smoke detector input on an ARTC/MultiFlex RTU
		has detected smoke.
SRAM Memory Corrupted -	30	A problem with memory has resulted in a reset of the
Reboot		E2.
State Switched ‘On’	User	A digital value that has been set up to alarm when
		ON has switched ON.
Status Config Loss-CRC Error	30	An internal error has occurred in the E2.
Stuck	30	MultiFlex ESR controller has detected a stuck valve.
System date needs manual reset	20	The date/time of the box is not valid.
System In Pump Down	User	The suction pressure has fallen below the pump down
		setpoint for a Suction Group, causing shutdown of
		the rack.
Template File Bad - CC100 Liq	15	A template file in E2 for a CC-100P or CC-100LS is
		bad.
Template File Bad - CC100 Suct	15	A template file in E2 for a CC-100H is bad.
Template File Bad - CS100 Ckt	15	A template file in E2 for a CS-100 is bad.
Test Dial Successful	50	E2 performed a test dial-out with its modem, and the
		dial-out was successful.
Time Updated By A User	99	A user changed the time in the current E2.
Time Updated Over Network	99	The time in the current E2 was updated by another
		controller or user on the network.
Timed Out Waiting For FW Updt.	50	The E2 waited for a firmware update to begin, and it
		never did.
Too Many Reboots: Flash erased	50	A number of successive reboots has erased the Flash
		RAM.
Too Many Reboots: SRAM erased	50	A number of successive reboots has erased the
		SRAM.
Total On Time Exceeded Limit	User	A digital value’s total ON time has exceeded its
		defined Time ON Total setpoint.
Trip Alarm	30	Generic pulse trip alarm.
Tripped	20	WPK condenser fan or compressor trip.
Unit Ctlr Cell Create Failed	20	The E2 unsuccessfully tried to create a unit controller
		cell.
Unknown FW Update Attempted	50	An error has occurred during a firmware update of
		E2. Call Emerson Retail Solutions service for assis-
		tance.
Unknown Heap Operation Error	50	There is an internal error in the E2 software. Notify
		Emerson Retail Solutions service.
Unoccupied Hi Limit Exceeded	User	An analog value has risen above its defined high limit
		setpoint during UNOCCUPIED mode.
Unoccupied Low Limit Exceeded	User	An analog value has fallen below its defined low
		limit setpoint during UNOCCUPIED mode.

Appendix C: Alarm Advisory Messages • C-13