Genicom 3600 manual Replacing the Stepper Motor, To replace the stepper motor

3600 Printer Maintenance Manual

Replacing the Stepper Motor

To replace the stepper motor, you will need the following parts and tools:

∙Main stepper motor and cable assembly, Intermec Part No. 061551-002

∙ESD grounding strap

∙#2 Phillips screwdriver

To replace the stepper motor

1.Switch off the printer power and remove the power cord, the media cover, and the electronics cover.

2.Unplug the motor cable from the main PCB and remove the motor from the motor plate and motor mount bracket.

Main PCB

Screw	Do not install
(3 places)	a screw in this
Stepper	Motor mounting hole.
motor	plate
	3600M.061

3.Mount the new motor loosely to the motor plate with the cable positioned at the bottom rear corner. Properly mesh the pinion gear with the platen drive gear and the liner drive gear before tightening the screws completely.

4.Plug the motor cable into the main PCB. Check that the motor cable-to- main PCB connection is correctly aligned before applying power to avoid damaging the main PCB.

5.Install the electronics cover, the media cover, and the power cord, and check the printer for proper operation.

5-30