Genicom 3600 manual Adjusting the Print Bias for Print Quality, To adjust the bias adjust screw

3600 Printer Maintenance Manual

Adjusting the Print Bias for Print Quality

Adjust the bias with a straight-slot screwdriver if the printhead is not making even contact with the media. Using different width media, especially narrow media, can result in uneven contact or a spot where there is no media between the printhead and the platen roller. Extra wear and damage can occur if narrow media is used for extended periods with incorrect bias.

To adjust the bias adjust screw

1. Remove the media cover and locate the bias adjust screw.

Power

Alert

Empty/Pause

Feed/Pause

In termec 3600

Printhead bias adjust screw

3600M.030

2.Turn the bias adjust screw counterclockwise to compensate for light print on the right side of the label; turn the bias adjust screw clockwise to compensate for light print on the left side.

If printing is light on the right side of label, turn the bias adjust screw counterclockwise.

*N AR RO WL E*

If printing is light on the left side of label, turn the bias adjust screw clockwise.

E* WL RO AR *N

3600M.031

3. Install the media cover.

3-14