Genicom 3600 manual Aligning the TTR Supply Hub, To align the TTR supply hub

Testing and Adjusting 3

Aligning the TTR Supply Hub

You should align the TTR supply hub only if you are experiencing ribbon wrinkle on full width ribbon after the rollers and printhead have been aligned. To perform this procedure, you need the following tools:

∙TTR supply hub alignment tool, Intermec Part No. T43149

∙#2 Phillips screwdriver

To align the TTR supply hub

1.Switch off the printer power.

2.Remove the media cover and the electronics cover.

3.Install the TTR supply hub alignment tool as shown.

Ribbon supply hub alignment tool

3600M.041

4.Tighten the alignment tool thumbscrew so the bushing tab is flush against the bushing on the hub adjustment plate.

5.Loosen the two screws securing the hub adjustment plate.

6.Switch on the printer power.

7.Print a series of the same kind of labels that were having the ribbon wrinkling problem. While they are printing, adjust the TTR supply hub up or down (with the thumbscrew on the tool) until ribbon wrinkling is eliminated.

3-25