Genicom 3600 manual Printhead alignment

3600 Printer Maintenance Manual

Note: This is a change in procedure from previous printhead alignment instructions that directed the printhead adjustment lever to be in the neutral/center position during alignment.

4.Install the printhead alignment tool and press the printhead assembly down on the platen roller. Align the tool with the notches in the heat sink and the printhead.

5.Alternately tighten the two 9/64 inch printhead yoke screws until secure.

6.Remove the printhead alignment tool.

7.Return the printhead adjustment lever to the neutral/center position.

8.Reload media (and ribbon if used).

9.Install the media cover and the power cord.

10.Switch on printer power and test for proper printhead alignment by printing out the print quality and pitch labels.

Printhead alignment

tool

Place the cutouts of the printhead alignment tool onto the shaft of the platen roller.

Printhead alignment tool

Guide pin

(Align with the notches

on the heatsink and printhead.)

Heatsink

Notch

Power

Alert

Empty/Pause

Feed/Pause

Intermec

3600

Printhead lift lever

3600M.040

3-24