Genicom 3600 manual Washer Ring

3600 Printer Maintenance Manual

5.Remove the TTR drive gear/pulley retaining E-ring. Retain the washer located between the E-ring and the TTR drive gear/pulley. Discard the old E-ring.

6.Remove the retaining snap ring that secures the printhead lift lever to the cam assembly shaft. Pull the printhead lift lever off of the printhead lift shaft. Discard the old snap ring.

Washer	E-ring	TTR drive
Washer		roller

E-ring

Cam assembly shaft

Printhead spring

Upper

outboard Printhead

plate lift Snap ring lever

3600M.054

7.Unhook the printhead spring from the upper outboard plate and remove the screws securing the plate to the printer. Pull the plate away, freeing up the TTR drive roller (and the TTR shaft, printhead pressure cam assembly, and pivot block).

8.Remove the TTR drive roller, sliding the gear/pulley off of the roller shaft. Retain the washer located between the roller and the main deck plate and the washer located between the gear/pulley and the main deck plate.

9.You can now replace either the TTR drive roller, the TTR drive gear/pulley, or both.

5-16