Genicom 3600 manual To replace the liner drive roller

3600 Printer Maintenance Manual

6.You can replace the liner takeup hub and/or liner reverse gear 1 now.

7.Install the thick washer removed in Step 5 between the liner takeup hub and the main deck plate. Position liner reverse gear 1 between the motor plate and the liner takeup subplate and check for proper engagement with liner reverse gear 2.

8.Insert the liner takeup hub through the main deck plate, reverse gear 1, and the subplate. Install the washer removed in Step 4 on the hub shaft extending through the subplate and secure with two new snap rings.

9.Reattach the front bezel cover. Ensure that the media access door operates properly (snaps firmly shut) after the front bezel cover is installed.

10.Reload media (and ribbon if used) and lower the printhead.

11.Install the electronics cover, the media cover, and the power cord, and check the printer for proper operation.

To replace the liner drive roller

1.If not already done, switch off the printer power and remove the power cord, media cover, electronics cover, and the front bezel cover. Raise the printhead and remove the media and ribbon if loaded.

2.Remove the five screws that secure the lower outboard plate to the main deck plate and pull the plate away from the rollers. The tear bar and tear bar support come loose when the outboard plate is removed. Retain them for reassembly.

Snap ring

Tear bar	Lower
Tear bar	outboard
	plate
support

Liner drive Washer

gear/pulley

E-ring

Liner drive roller

3600M.059

5-26