Genicom 3600 manual Aligning the Rollers, To align the rollers

3600 Printer Maintenance Manual

Aligning the Rollers

You should perform this procedure every time an outboard plate is removed or replaced. To perform this procedure, you need the following tools:

Note: If the printer you are servicing has upper outboard plate Intermec Part No. 062476-002 installed, you need to replace it with a new upper outboard plate Intermec Part No. 063225-001 before you can perform the following roller alignment.

∙Roller alignment tool, Intermec Part No. T43150

∙#2 Phillips screwdriver

To align the rollers

1.Switch off the printer power and remove the power cord.

2.Remove the media cover, the electronics cover, and the front bezel cover (refer to Chapter 5, “Remove and Replace Procedures,”for detailed instructions).

3.Raise the printhead with the printhead lift lever. Remove media and ribbon if loaded.

4.Loosen the Phillips screws on the outboard plate that you are aligning.

Note: Align only one outboard plate at a time (either the upper or the lower) to put the rollers back into factory alignment. If both plates are loosened, it may not be possible to align the rollers outside of the factory.

5.Align the three holes in the roller alignment tool with the platen roller, the liner roller, and the TTR roller. The fourth hole in the roller alignment tool fits over the black plastic cap closest to the front of the printer.

UP→

3600M.038

3-22