Genicom 3600 manual Replacing the Bezel PCB, To replace the bezel PCB assembly

3600 Printer Maintenance Manual

5.Use a straight-slot screwdriver to loosen the printhead retaining screws, located in the center of the printhead heatsink. The screw is easier to loosen if you place one of your fingers underneath the printhead, between the printhead and the platen roller. Pull the printhead away from the printer (since it is a tight fit, you may need to pull it out from the outboard side rather than from the front).

6.Replace the printhead and cable and tighten the printhead retaining screws.

7.Reload media (and ribbon if used) and lower the printhead.

8.Install the media cover and the power cord and check the printer for proper operation.

Replacing the Bezel PCB

To replace the bezel PCB, you will need the following parts and tools:

∙Bezel PCB assembly, Intermec Part No. 059052S-001

∙ESD grounding strap

∙#1 and #2 Phillips screwdrivers

To replace the bezel PCB assembly

1.Switch off the printer power and remove the power cord.

2.Remove the media cover and the electronics cover.

3.Unplug the bezel PCB assembly from the main PCB and remove the five screws that hold the front bezel cover to the printer.

Power

Alert

Empty/Pause

Feed/Pause

Intermec

3600

Front bezel
cover	3600M.044

5-6