Genicom 3600 Replacing the Printhead, Remove and Replace Procedures, To replace the printhead

Remove and Replace Procedures 5

Replacing the Printhead

To replace the printhead, you will need the following parts and tools:

∙6.6-inch 5 mil printhead, Intermec Part No. 061611S-001

∙ESD grounding strap

∙Medium straight-slot screwdriver

To replace the printhead

1.Switch off the printer power and remove the power cord.

2.Remove the media cover.

3.Raise the printhead. Remove media and ribbon if loaded.

4.Release the locks on the printhead cable by pressing in on each side of the cable connector. Remove the printhead cable.

Note: If you need slack to separate the printhead and cable, unplug the cable from the main PCB and pull some of it through the cutout in the main deck plate.

Straight slot

screwdriver Cable Printhead

connector cable

Power

Alert

Empty/Pause

Feed/Pause

Intermec

3600

Printhead retaining screw

Power

Alert

Empty/Pause

Feed/Pause

Intermec

Printhead

3600M.043

5-5