Genicom 3600 manual Upper media guide Label gap sensor

3600 Printer Maintenance Manual

Upper media guide

Label gap sensor

	Label gap
	sensor
Lower	housing
media
guide	Locking
	tabs
	Lift spring
	3600M.052

6.Use a small straight-slot screwdriver to lift up on each of the two molded tabs that secure the label gap sensor. Slide the label gap sensor from its housing and replace it with the new label gap sensor. The label gap sensor should snap into place.

7.Slide the upper media guide plate back together with the lower media guide plate.

8.Route the label gap sensor cable through the cutout in the main deck plate and reattach the media guide assembly to the frame. Be sure that the media brake arm does not rub on the upper media guide and that the sensor cable is not contacting any moving parts.

9.Attach the label gap sensor cable to the main PCB.

10.Reload media (and ribbon if used) and lower the printhead.

11.Install the electronics cover, the media cover, and the power cord, and check the printer for proper operation.

5-14