Genicom 3600 manual Replacing the Transformer, To replace the transformer

Remove and Replace Procedures 5

4.Compress the tabs that hold the power switch secured to the back plate and push it out of the main deck plate.

5.Install the power switch by pushing the new receptacle into the cutout in the main deck plate.

6.Reattach the two push-on connectors removed in Step 3.

7.Install the electronics cover, the media cover, and the power cord, and check the printer for proper operation.

Replacing the Transformer

To replace the transformer, you will need the following parts and tools:

Note: The printer uses a different transformer for 220-volt and 115-volt printers.

∙XFMR, 3600, 47-63HZ, 100V/120V, Intermec Part No. 585525-001 or XFMR, 3600, 47-63HZ, 200V/240V, Intermec Part No. 585525-002

∙ESD grounding strap

∙#2 Phillips screwdriver

To replace the transformer

1.Switch off the printer power and remove the power cord, the media cover, and the electronics cover.

2.Disconnect the transformer cable from the main PCB and the two leads with push-on connectors from the AC power plug and the power switch.

Transformer

Screw

(2 places)

Power switch/ circut breaker

Main PCB

AC power plug

3600M.064

5-33