Remove and Replace Procedures 5

Replacing the Label Gap Sensor

To replace the label gap sensor, you will need the following parts and tools:

Label gap cable assembly, Intermec Part No. 059495-001

ESD grounding strap

Small straight-slot screwdriver

12-inch shank #2 Phillips screwdriver

To replace the label gap sensor

1.Switch off the printer power and remove the power cord, the media cover and the electronics cover.

2.Raise the printhead. Remove media and ribbon if loaded.

3.Disconnect the label gap sensor cable from the main PCB.

Gap sensor cable

Label gap sensor

Upper and lower media guide assembly

3600M.051

4.Remove the three screws securing the upper/lower media guide assembly to the main deck plate.

5.Slide the upper media guide outward to separate it from the rest of the assembly.

5-13

Page 99
Image 99
Genicom 3600 manual Replacing the Label Gap Sensor, To replace the label gap sensor