Genicom 3600 manual Aligning the Printhead, To align the printhead

Testing and Adjusting 3

6.When the tool fits properly on all of the rollers and the bushing, tighten the screws on the outboard plate that you are aligning.

7.Reattach the front bezel cover. Ensure that the media access door operates properly (snaps firmly shut) after the front bezel cover is installed.

8.Install the electronics cover.

9.Reload media (and ribbon if used).

10.Install the media cover and the power cord.

11.Switch on printer power and check for proper operation.

Aligning the Printhead

Align the printhead only if necessary. To perform this procedure, you need the following tools:

∙Printhead alignment tool, Intermec Part No. T43099

∙9/64-inch Allen screwdriver

To align the printhead

1.Switch off the printer power. Remove the power cord and the media cover.

2.Raise the printhead with the printhead lift lever. Remove media and ribbon.

3.Position the printhead adjustment lever clockwise/left two clicks during the printhead alignment. Loosen the two Allen screws located on the printhead yoke at the back of the printhead heatsink.

Printhead adjustment lever

	printhead
moves	forward

I

O

printhead moves backward

3600M.039

3-23