Genicom 3600 manual Replacing the TTR Takeup Hub, Clutch/Pulley, and Belt

3600 Printer Maintenance Manual

Replacing the TTR Takeup Hub, Clutch/Pulley, and Belt

To replace the TTR takeup hub, TTR takeup clutch/pulley, and TTR takeup drive, you will need some or all of the following parts and tools:

∙TTR takeup hub, Intermec Part No. 061562-005

∙TTR takeup clutch assembly, Intermec Part No. 062927S-001 (white)

∙2.800ID x .210 drive belt (O-ring), Intermec Part No. 501462-003

∙Retaining snap rings, Intermec Part No. 501410

∙ESD grounding strap

∙Snap ring pliers

∙#1 and #2 Phillips screwdriver

To remove the TTR takeup hub, TTR takeup clutch/pulley, and TTR drive belt

1.Switch off the printer power and remove the power cord.

2.Remove the media supply cover, the electronics cover, and the front bezel cover (refer to “Replacing the Bezel PCB” earlier in this chapter).

3.Raise the printhead. Remove media and ribbon if loaded.

4.Remove the two TTR takeup clutch/pulley retaining snap rings and the thick washer from the end of the TTR takeup hub shaft. Retain the washer. Discard the old snap rings.

TTR takeup	TTR clutch/
	pulley
drive belt	Thin washer

TTR takeup hub

Thick washer

Snap ring

TTR drive gear/pulley

3600M.055

5-18