Genicom 3600 manual Replacing the Main PCB, To replace the main PCB assembly

3600 Printer Maintenance Manual

Replacing the Main PCB

To replace the main PCB, you will need the following parts and tools:

∙3600 main PCB assembly, Intermec Part No. 061591S-005 or 06159E-005

∙ESD grounding strap

∙#2 Phillips screwdriver

To replace the main PCB assembly

1.Switch off the printer power and remove the power cord, the media cover, and the electronics cover.

2.Unplug all of the cables from the main PCB and remove the seven screws securing the main PCB to the printer to remove the main PCB. Do not place the printer on its side as this may disturb alignments.

Main PCB assembly

J9

Power

Alert

Empty/Pause

Feed/Pause

Intermec

3600

3600M.046

3.If the main PCB you are replacing has the 512K SRAM memory expansion chip, verify that the new main PCB is similarly equipped. If it is not, carefully unplug the existing 512K chip and plug it into the new main PCB before installing it.

4.If the main PCB you are replacing has a Kanji/Katakana option PCB installed, use the next procedure to relocate the Kanji/Katakana option PCB to the new main PCB before installing it.

5.Install the new main PCB, securing it with the seven screws removed in Step 3, and connect all of the cables.

6.Install the electronics cover, the media cover, and the power cord, and check the printer for proper operation.

5-8