Genicom 3600 manual Replacing Printer Components

Remove and Replace Procedures 5

This chapter contains illustrated instructions for removing and replacing key components of the 3600 printer.

Replacing Printer Components

WARNING

CAUTION

When a printer component needs replacing, use the appropriate following procedure. See Chapter 7, “Replacement Parts,” for a complete list of spare parts.

After replacing a component, refer to Chapters 2 and 3 for the procedures to complete the repair by ensuring that you leave the printer performing at its optimum level.

Prior to taking any action, review all warnings, cautions, and procedures associated with any component you intend to remove.

When performing any of the procedures in this chapter, heed the following warnings and cautions at all times to avoid the consequence identified.

Warning

Always disconnect the power cord before removing the electronics cover unless the procedure requires the unit be energized. Failure to disconnect the power cord may result in injury or death due to electric shock.

Caution

The printhead and integrated circuits on printer circuit boards in this equipment are sensitive to damage by electrostatic discharge (ESD). Prevent ESD by always wearing skin contact ground straps firmly attached to the equipment metal base assembly when working inside of the equipment housing. Failure to comply can result in damage to components or the printhead.

Caution

Do not remove the motor plate or subplates. Changing the position

CAUTION of the motor plate can alter factory alignment and cause ribbon wrinkling or liner-stripping problems.

5-3