98
Troubleshooting

Regarding the indicator lamps

When operation of the LAMP,TEMP and POWER indicators differs from usual,

check and cope with it according to the following table.

POWER
indicator
LAMP
indicator
TEMP
indicator Description
Lighting
InOrange
Turned
off
Turned
off

The projector is in a standby state.

Please refer to the section “Power on/off”.
Blinking
InGreen
Turned
off
Turned
off

The projector is warming up.

Please wait.
Lighting
InGreen
Turned
off
Turned
off

The projector is in an on state.

Ordinary operations may be performed.
Blinking
InOrange
Turned
off
Turned
off

The projector is cooling down.

Please wait.
Blinking
InRed
(discre-
tionary)
(discre-
tionary)

The projector is cooling down. A certain error

has been detected.

Please wait until POWER indicator nishes blinking,
and then perform the proper measure using the item
descriptions below.
Blinking
InRed
or
Lighting
InRed
Lighting
InRed
Turned
off

The lamp does not light, and there is a possibility

that interior portion has become heated.

Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
sufciently cooled down, please make conrmation of
the following items, and then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air lter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the remedy,
please change the lamp referring to the section
“Replacing the lamp”.
Blinking
InRed
or
Lighting
InRed
Blinking
InRed
Turned
off

7KHODPSFRYHUKDVQRWEHHQSURSHUO\¿[HG

Please turn the power off, and allow the projector to
cool down at least 45 minutes. After the projector has
sufciently cooled down, please make conrmation of
the attachment state of the lamp cover. After performing
any needed maintenance, turn the power on again.
If the same indication is displayed after the remedy,
please contact your dealer or service company.
Blinking
InRed
or
Lighting
InRed
Turned
off
Blinking
InRed

The cooling fan is not operating.

Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
sufciently cooled down, please make conrmation
that no foreign matter has become caught in the fan,
etc., and then turn the power on again.
If the same indication is displayed after the remedy,
please contact your dealer or service company.
(Continued on next page)