Hitachi ED-A220N user manual Communication setup, Communication port, Condition, Baud Rate

6. Network Bridge Function

6.2 Communication setup

To congure the setup of the communication using NETWORK BRIDGE for the projector, use items in the COMMUNICATION menu. Open the menu of the projector and select the OPTION - SERVICE - COMMUNICATION menu. (OPTION menu – SERVICE – COMMUNICATION in the User’s Manual – Operating Guide)

1)Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE for the CONTROL port.

2)Using the SERIAL SETTINGS menu, select the proper baud rate and parity for the CONTROL port, according to the specication of the RS-232C port of the connected device.

Item	Condition
BAUD RATE	4800bps/9600bps/19200bps/38400bps
PARITY	NONE/ODD/EVEN
Data length	8 bit (xed)
Start bit	1 bit (xed)
Stop bit	1 bit (xed)

3)Using the TRANSMISSION METHOD menu, set up the proper method for the CONTROL port according to your use.

NOTE • The OFF is selected for the COMMUNICATION TYPE as the default setting.

•Using the COMMUNICATION menu, set up the communication. Remember that an unsuitable setup could cause malfunction of communication.

•When COMMUNICATION TYPE is set to NETWORK BRIDGE, the CONTROL port doesn't accept RS-232C commands.

6.3 Communication port

For the NETWORK BRIDGE function, send the data from the computer to the projector with using the Network Bridge Port that is congured in the “Port Settings” of web browser. (51)

NOTE • Except for 9715, 9716, 9719, 9720, 5900, 5500, 4352 between 1024 and 65535 can be set up as the Network Bridge Port number. It is set to 9717 as the default setting.

75