Setting up

Connecting to a power supply

1. Put the connector of the power cord into the AC IN (AC inlet) of the projector.

2. Firmly plug the power cord’s plug into the outlet. In a couple of seconds after the power supply connection, the POWER indicator will light up in steady orange.

AC IN

Power cord

Please remember that when the DIRECT POWER ON function activated (53), the connection of the power supply make the projector turn on.

WARNING Please use extra caution when connecting the power cord, as incorrect or faulty connections may result in re and/or electrical shock.

Only use the power cord that came with the projector. If it is damaged, consult your dealer to get a new one.

Only plug the power cord into an outlet whose voltage is matched to the power cord. The power outlet should be close to the projector and easily accessible. Remove the power cord for complete separation.

Never modify the power cord.

Using the security bar and slot

A commercial anti-theft chain or wire up to 10 mm in diameter can be attached to the security bar on the projector.

Also this product has the security slot for the Kensington lock.

For details, see the manual of the security tool.

Security slot

Security bar

Anti-theft chain or wire

WARNING Do not use the security bar and slot to prevent the projector from falling down, since it is not designed for it.

CAUTION Do not place anti-theft chain or wire near the exhaust vents. It may become too hot.

NOTE • The security bar and slot is not comprehensive theft prevention measures. It is intended to be used as supplemental theft prevention measure.

14

Page 23
Image 23
Hitachi ED-A220N user manual Connecting to a power supply, Using the security bar and slot