4
1. Connection to the network

1.1 System requirements

1. Connection to the Network

The following equipments are required to connect the projector to your computer
through the network.
The “LiveViewer” software needs to be installed on all the computers to connect
to the projector through a network. To use the “LiveViewer” your computer needs
to meet the following requirements.
1.1.1 Required equipment preparation
1.1.2 Hardware and software requirement for computer
9Projector
9LAN cable (to connect the projector to a network): CAT-5 or greater
9Computer (minimum 1 set): equipped with the network feature
(100Base-TX or 10Base-T)
9OS: One of the following.
Windows ® XP Home Edition /Professional Edition (32 bit version only)
Windows Vista® Home Basic /Home Premium /Business /Ultimate /Enterprise (32
bit version only)
Windows® 7 Starter /Home Basic /Home Premium /Professional /Ultimate /
Enterprise (32 bit version only)
9CPU: Pentium 4 (2.8 GHz or higher)
9Graphic card: 16 bit, XGA or higher
* When using the “LiveViewer” it is recommended that the display resolution of
your computer is set to 1024 x 768.
9Memory: 512 MB or higher
9Hard disk space: 100 MB or higher
9Web browser: Internet Explorer® 6.0 or higher
9CD-ROM drive
• The network communication control is disabled while the projector is
in standby mode if the STANDBY MODE item is set to SAVING. Please connect
the network communication to the projector after setting the STANDBY MODE
to NORMAL. (SETUP menu in the User’s Manual – Operating Guide)
• You can get the latest version of the “LiveViewer” and the latest information
for this product from our website. (7)
•
Depending on the specication of your computer, the computer may slow down
due to high CPU usage when the "LiveViewer" is running.
• The “LiveViewer” does not work on Windows Vista® that is not updated to
Service Pack 1 or later. Please install the latest Service Pack on your Windows
Vista®.
NOTE