1. Connection to the network

1.2 Installing the “LiveViewer”

1.2.1 Installing the “LiveViewer”

The “LiveViewer” software needs to be installed on all the computers to connect to the projector through a network.

You need to log in as an administrator user to install the software.

1)Turn on the computer.

2)Shut down all applications.

3)Insert the accompanying CD-ROM into the computer's CD-ROM drive.

NOTE • After sequence 3), the User Account Control (UAC) dialog will appear (if you are using Windows Vista® or Windows® 7). Please click the [Allow] to continue installation.

4)After a moment, the Choose Setup Language dialog will appear as shown on the right. Select what you like to use in the list, and click the [OK].

NOTE • If the Choose Setup Language dialog doesn't appear, proceed as follows:

(1)Click on the [Start] button on the toolbar and select the “Run”.

(2)Enter E:\setup.exe and then press the [OK].

If your CD-ROM drive is not drive E on your computer, you will need to replace E with the correct drive letter assigned to your CD-ROM drive.

If the software has been already installed, Uninstallation will be done. Click the [Cancel] button, then uninstallation will be canceled. If you uninstalled the software by miss-operation, please re-install the software from rst procedure.

5)After a moment, the Welcome dialog will appear as shown on the right. Press the [Next].

6

Page 119
Image 119
Hitachi ED-A220N user manual Installing the LiveViewer