Hitachi ED-A220N user manual Conguring the network settings manually

1. Connection to the network

1.7 Conguring the network settings manually (continued)

Wireless LAN

1)The setting on the access point. *1 Enter the following information.

SSID: WirelessAccessPoint (example)

Encryption: WEP64bit (example)

Encryption key *2: ********** (example)

Mode: INFRASTRUCTURE

2)Click the [Next].

3)Enter the following information that is set in the projector. *3

IP address : 192.168.1.10 (example)

Subnet mask: 255.255.255.0 (example)

4)Click the [Connect].

5)The wireless connection will be established.

Proceed to item 1.8 Confirming the connection to your destination. (30)

*1 Contact the network administrator to nd out the setting on the access point. *2 If you use an encryption, you need to set it. Contact the network administrator

to check the encryption key that is set in the projector.

The encryption key is always shown as “**********”.

*3 To nd the network setting on the projector, refer to the NOTE. (22)

26