Hitachi J300U Series Output full-scale value, Current monitor, Terminal connection example

Extension

function

code

Contents and display

Select the output monitors signal at the control circuit terminal FM from the table indicated below.

Monitor signal selection

Setting method

	2		➤
			1
FUNC
	➤

➤

Initial value

FUNC

➤

	Set value	Function
Initial value	0	Analog output frequency monitor
	1	Analog current monitor
	2	Analog torque monitor (Note)
	3	Digital output frequency monitor

Frequency converted value setting

Analog input selection

Output monitor signal			Output full-scale value		NOTE: Use the analog torque monitor function only in the
					sensorless state. Under the V/f control, an appropriate
Analog	Frequency monitor			Maximum frequency	value is outputted. The accuracy is ±20%
					(a rough value).
	Current monitor	200% of the rated current
	Torque monitor	200% of the rated torque

Set a converted value for frequency converted value monitoring. The product of this setting and the ouptut frequency (d0) is displayed as the value for the frequency converted value monitor (d3).

Setting method	.
	➤
2	1
FUNC	➤	FUNC
➤	.	➤
Initial value
	➤
2	1
	➤

.

Set the maximum voltage to be supplied between the terminals 0 and L.

H

O

01

L

H

O

01

L

Setting method

+

Ð

DC0 TO 5V

VR0

➤

DC0 TO 10V

(500 Ω to 2kΩ)

2

1

Input impedance

FUNC

➤

FUNC

30 kΩ

Terminal connection example

➤	➤	Set value	Function
Initial value
		0	Max. 5 V input

Initial value 1 Max. 10 V input

7-22