Hitachi J300U Series instruction manual 12-13

Display	(Function mode 1)		(Function mode 2)				Setting, change
	Function	Function	Initialization display			Initialization		Setting contents
sequence							contents
	No.	name	contents
30	F-37	Monitor	MONITOR		A-F	A-F	A-F/A/T/D-F	• The FM terminal monitor
		signal						signal output is selected.
		selection						A-F: Analog frequency
								T: Torque monitor
								A: Current monitor
								D-F: Digital frequency
31	F-38	Trip history	INIT TCNT		CNT	CNT	CNT/CLR	• Trip count deletion selection
	Initiali-	count clear						CNT: Trip counting is
	zation							continued.
								CLR: The trip count is cleared.
		Debug	INIT DEBG		OFF	OFF	ON/OFF	• Debug mode setting ON or
		mode						OFF
		display						OFF: The debug mode is
		selection						turned off.
						NOTE 1		ON: The debug mode is turned
								on.
		Digital	INIT DOPE		FWD	FWD	FWD/REV	• The digital operator running
		operator						direction is set.
		rotation						FWD: Forward run
		direction						REV: Reverse run
		selection
		Selection of	INIT RESET		ON	ON	ON/OFF	ON: Alarm release when reset
		reset						on
		performance						OFF:Alarm release when reset
								off
32	F-39	Encode	OP P	01024 pulse		1024	255 to 65535	Effective with option board
	Option	pulse						(J-FB)
	setting	number
		setting
		Control	OP MODE		ASR	ASR	ASR/APR
		mode
		selection
		Ro-To	OP RO-TO		OFF	OFF	OFF/ON	Keep OFF. (No use)
		option
		selection
33	F-40	Stop	OR POS		IN	IN	IN/OUT	Effective with option board
	Orientation	position						(J-FB)
	setting	setting
		switching
		Stop	OR P	00000 pulse		0	0 to 4095
		position
		setting
		Speedsetting	OR FC		0005.0 Hz	5.0 Hz	0 to 400 Hz
		Direction	OR TURN		FWD	FWD	FWD/REV
		setting
		Completion	OR L	00005 pulse		5	0 to 10000
		rangesetting
		Completion	OR TW		0.00 s	0	0 to 9.99
		delay time
		setting

NOTE 1 : Keep debug mode " OFF " , this is factory use only.

12-13