Hitachi J300U Series instruction manual Monitor mode, 12-3

12.2Monitor mode

Monitor mode list when the remote operator (DOP) and copy unit (DRW) are used

•Monitor mode initial values and display contents

Initial display contents, initialization, and change ranges are displayed in the table indicated below.

Y : Setting can be changed during operation

N: Setting can not be changed during operation

:Display only

Display							Setting	Setting and
	Monitor name		Display content		Initial value			change are			Remarks
sequence							range
								possible?
1	Frequency setting	1		2	0.0 Hz		0 to 120		Y	(1) displays the setting.
	and output		FS0000.0	0.0Hz			(400)			(2) displays the output.
	frequency									•	is displayed
		1		2							when run
					0.0 Hz						instruction is ON.
			TM 0.0	0.0Hz
										F: Forward run
			1S0000.0	0.0Hz	0.0 Hz					R: Reverse run
	Multistage-speed
	setting and out-		2S0000.0	0.0Hz
	put frequency
			3S0000.0	0.0Hz
	Jogging frequency		JG0000.0	0.0Hz	1.0 Hz		0 to 9.9		Y	A trip occurs easily
	setting									at 5 Hz or more.
										• Valid when the mult-
											istage speed terminal
			4S0000.0	0.0Hz							3 is selected.
										• The multistage speed
	Expansion
					0.0 Hz		0 to 120		Y		are displayed when
	multistage speed						(400)				the input terminal is
			7S0000.0	0.0Hz							connected.
										• For terminal setting,
											refer to F-34 "Input
											terminal setting".
2	Acceleration time		ACC1	0030.00S	30.0S		0.01 to		Y
	setting						3000.00
3	Deceleration time		DEC1	0030.00S	30.0S		0.01 to		Y
	setting						3000.00
4	Frequency setting		F-SET-SELECT REM		TRM		TRM/REM		N	REM: Setting from
	command						OP1/OP2			the remote operator
5	Operation command		F/R-SELECT REM		TRM		TRM/REM		N	TRM: Setting from the
							OP1/OP2			inverter terminal
6	Motor pole count									Synchronized speed
	setting and revolu-		RPM 4P	0RPM		4P	2 to 48		Y
										display
	tion speed monitor
7	Frequency converted									The arithmetic value
	value setting and		/Hz01.0	0.00	1.0		0 to 99.9		Y	by the frequency
	converted value									converted value is
	monitor									displayed. (NOTE 1)
8	Current monitor	1		2						The (1) section depends
										on the INV rated
			Im 0.0 A	0.0%
										current.
										The (2) section
										displays the rate to the
										rated output current.
9	Torque monitor		Torque	0%
10	Manual torque				11				Y
			V-Boost code <11>				0 to 99
	boost adjustment

NOTE 1: The terminal output when the digital output frequency monitor is set at the FM terminal of the control circuit is the "output frequency × frequency converted value". The upper limit of output is 3.6 kHz.

12-3