Hitachi J300U Series instruction manual 12-12

Display	(Function mode 1)		(Function mode 2)				Setting, change
	Function	Function	Initialization display			Initialization		Setting contents
sequence							contents
	No.	name	contents
27	F-34	Input	IN-TM 6		USP	USP	USP and 17
	Intelligent	terminal 6				Power-ON	other terminals
	terminal	setting				restart
	input					preventionl
	terminal	Input	IN-TM 7		CF1	CF1	CF1 and 17
	setting	terminal 7				Multi-stage	other terminals
		setting				input
						terminal
		Input	IN-TM 8		REV	REV reverse	REV and17
		terminal 8				run command	other terminals
		setting				input terminal
		Input	IN-TMO/C-1		NO	NO	NO/NC	• Input terminal setting
		terminal 1						NO: ON when short-
		NO/NC						circuited
		setting						NC: ON when opened
		Input	IN-TM O/C-2		NO	NO	NO/NC	• Input terminal setting
		terminal 2						NO: ON when short-
		NO/NC						circuited
		setting						NC: ON when opened
		Input	IN-TM O/C-3		NO	NO	NO/NC	• Input terminal setting
		terminal 3						NO: ON when short-
		NO/NC						circuited
		setting						NC: ON when opened
		Input	IN-TM O/C-4		NO	NO	NO/NC	• Input terminal setting
		terminal 4						NO: ON when short-
		NO/NC						circuited
		setting						NC: ON when opened
28	F-35	Output	OUT-TM 1		FA1	FA1	FA1/RUN/OTQ	Output terminal setting
	Intelligent	terminal						FA1: Frequency arrival signal
	terminal	11 setting						RUN: Signal during run
	output							OTQ: Overtorque signal
	terminal	Output	OUT-TM 2		RUN	RUN	FA1/RUN/OTQ	Output terminal setting
	setting	terminal						FA1: Frequency arrival signal
		12 setting						RUN: Signal during run
								OTQ: Overtorque signal
		Alarm	OUT-TM	O/C-A NC		NC	NC/NO	• Alarm output terminal
		output						contacts a and b setting
		NO/NC						NC: b contact
		setting						NO: a contact
		Output	OUT-TM	O/C-1 NO		NO	NO/NC	• Output terminal 1 contacts
			terminal					a and b setting
		11 NO/NC						NO: b contact
		setting						NC: a contact
								Refer to	C	21
		Output	OUT-TM O/C-2		NO	NO	NO/NC	• Output terminal 12 contacts
		terminal						a and b setting Short-
		12 NO/NC						NO: a contact
								NC: b contact
29	F-36	Carrier	CARRIER	16.0 kHz		16.0 kHz	2.0 to 16.0 Hz	• The IPM carrier frequency
		frequency					Selectable	is set.
		setting					in 0.1 steps	• The setting value varies
								with the capacity.

12-12