Hitachi J300U Series instruction manual Pid

Extension

function

code

Contents and display

Possible to select a performance of a release timing of alarm signal when giving reset signal

Selection of reset terminal perfor- mance

from [RS] terminal

FUNC Initial value

➤

2		➤
		1
	➤

FUNC

➤

Set value

Reset signal from [RS] terminal Alarm output

Reset signal from [RS] terminal Alarm output

Performance

➤

➤

These functions are used to set PID control operation gains.

P (Proportional) gain, I (Integral)

gain, D (Differential) gain

Set each gain.

Setting method

.

	Gain adjusting range
P	0.0 to 5.0
I	0.0 to 15.0 s
D	0 to 100.0

Propor- tional gain setting

Integral gain setting

Differential gain setting

PID

	2	➤	1
FUNC		➤		FUNC

➤	.	➤
Initial value
2	➤
	1
	➤

.

This function is used to control the PID functions incorporated in the inverter.

This function is also used to select a feed-back signal input and set a magnification of the integral gain setting value.

For details of PID control, refer to "Appendix 8 PID Control Functions".

control

selection

Setting method

	2		➤
			1
FUNC
		➤

➤

Initial value

FUNC

➤

Setting	Feed-back signal	I (Integral) gain
value	input terminal	magnification
0	Built-in PID function disabled.
1	Analog current (OI-L)	× 1
2	Analog voltage (O-L)	× 1
3	Analog current (OI-L)	× 10
4	Analog voltage (O-L)	× 10

Note 1: Set "0" for the use of a PID optional board.

Note 2: Do not assign a feed-back signal input and an target frequency command to the same terminal. If assigned, the PID function will be disabled.

7-26