| Adhesive Labels |
| Use only labels recommended for use in laser printers. To purchase |
C a u t i o n | |
| labels, consult your HP authorized dealer or see “Accessories and |
| Ordering Information” starting on page |
|
|
C a u t i o n
When selecting labels, consider the quality of each component:
∙Adhesives: The adhesive material should be stable at the 392° F (200° C) temperature encountered in the printer’s fusing process. None of the adhesive backing should be exposed between the labels.
∙Label arrangement: It is best to use labels with no exposed backing between labels. If labels with exposed areas are used, arrange them on the carrier sheet (the backing) so that they cover the entire page with the exposed areas of the carrier sheet running lengthwise down the sheet. Using label stock with spaces between labels often causes labels to peel off during the printing cycle, causing serious jamming problems.
∙Label curl: Prior to printing, labels must lie flat with no more than 0.5 in (13 mm) of curl in any direction.
∙Poorly manufactured labels: Do not use labels with wrinkles, bubbles, or other indications of delamination.
Label Guidelines
∙Do not use labels that are separating from the backing sheet or that are wrinkled or damaged in any way.
∙Do not feed a sheet of labels through the printer more than once. The label adhesive is designed for only one pass through the printer.
∙Load labels
∙Use the rear output tray for labels.
Do not print labels from Tray 2; always use Tray 1.
Media B Specifications
EN
Media Specifications