
Loading Media into Tray 1
Tray 1
100 sheets of paper or up to 10 envelopes.
1Grasp Tray 1 by the two finger tabs and pull the top down.
2Pull out the plastic tray extender by grasping the center finger tab. If the media being loaded is longer than
9 inches (229 mm), also pull out the wire tray extender.
3Slide the paper width guide to the far right side of the tray.
4Place media into the tray
5Slide the paper width guide to the left until it lightly touches the media without bending it. Make sure the media fits under the tab on the paper width guide.
N o t e
Do not add media to Tray 1 while the printer is printing. This could cause a paper jam.
Tray 1 hint
∙For letterhead orientation in Tray 1, see page
3 Printing Tasks
EN
Printing Tasks