6Remove the SIMM from the antistatic package while avoiding touching the metal contacts.
7Hold the SIMM so the notch on one end is on the bottom and the metal contacts face toward the slot.
8Hold the SIMM at a 30 degree angle to the first available slot from the right. Push the edge of the board evenly and firmly into the slot (D). Rotate the SIMM to the right (E) until the board snaps into the locking tabs.
Repeat steps 6, 7, and 8 for each SIMM being installed.
9Replace the side panel by lining up the alignment arrows (F) and sliding the panel backwards (G) until the release button latches into place (H). Close the top cover.
10Reinstall the interface cable(s) and power cord. Turn the printer on.
Continue on the following page.
EN |
D Memory
Installation
Memory Installation
