Attaching a Macintosh Printer Cable

You can directly connect the printer to a Macintosh (or Macintosh-compatible) computer using either a LocalTalk or Macintosh serial cable.

N o t e

To connect the printer to a LocalTalk

Network, see Appendix C.

C a u t i o n

Make sure power is off.

1 Locate the interface cable door (A) at the back of the printer.

2 Pull the door out using the finger tab for leverage.

3 Plug the cable into the printer’s LocalTalk port. If the cable does not slip on easily, make sure the pin orientation matches the illustration.

4 Replace the interface cable door while allowing the cable to feed through the top hole.

5 Connect the other end of the cable to the proper connector on the computer.

1 Printer Setup

EN

Printer Setup 1-11

Page 20
Image 20
HP 6MP, 6p manual Attaching a Macintosh Printer Cable