HP C410b Set up the HP Photosmart for faxing, Countries/regions with a parallel-type phone system

Chapter 3

Set up the HP Photosmart for faxing

Before you begin setting up the HP Photosmart for faxing, determine which kind of phone system your country/region uses. The instructions for setting up the HP Photosmart for faxing differ depending on whether you have a serial- or parallel-type phone system.

•If you do not see your country/region listed in the table below, you probably have a serial-type phone system. In a serial-type phone system, the connector type on your shared telephone equipment (modems, phones, and answering machines) does not allow a physical connection to the "2-EXT" port on the HP Photosmart. Instead, all equipment must be connected at the telephone wall jack.

NOTE: In some countries/regions that use serial-type phone systems, the phone cord that came with the HP Photosmart might have an additional wall plug attached to it. This enables you to connect other telecom devices to the wall jack where you plug in the HP Photosmart.

•If your country/region is listed in the table below, you probably have a parallel-type telephone system. In a parallel-type phone system, you are able to connect shared telephone equipment to the phone line by using the "2-EXT" port on the back of the HP Photosmart.

NOTE: If you have a parallel-type phone system, HP recommends you use the 2-wire phone cord supplied with the HP Photosmart to connect the HP Photosmart to the telephone wall jack.

Table 3-1 Countries/regions with a parallel-type phone system

		Argentina	Australia	Brazil
		Canada	Chile	China
		Colombia	Greece	India
		Indonesia	Ireland	Japan
		Korea	Latin America	Malaysia
		Mexico	Philippines	Poland
		Portugal	Russia	Saudi Arabia
Finish		Singapore	Spain	Taiwan
		Thailand	USA	Venezuela
settinguptheHPPhotosmart
		Vietnam
16	Finish setting up the HP Photosmart