!

750C Plus

Troubleshooting

Solving Problems with Plot Position or Content

If the Plot Is Distorted or Unintelligible

The interface cable between your computer and the plotter could be faulty. Try another cable to see if the problem is corrected.

If you are using a serial interface between the plotter and your computer, make sure the plotter's serial interface settings match the settings and requirements of your software and hardware. See page 1-29.

If One Plot Overlays Another Plot on the Same Sheet

The I/O Setup / I/O Timeout setting may be too long. Decrease the setting and plot again. See page 7-9.

If Device setup / Lang is set to 7586,HP±GL/2 (the default), try changing the Terminator setting and send the files again.

If Pen Settings Seem To Have No Effect

Either you have changed them in Pen settings / Define palette but forgotten to select that palette in Pen settings / Palette,

or you expected the software-driven pen settings but the front panel Pen settings / Palette is not set to Software.

See page 5-6.

If the Plotter Produces a Black and White Plot When You Expected a Color Plot

Check the front panel Color/Mono setting, and the equivalent setting in your software.

9-14