Message | Explanation and Action |
STATUS | The cartridge carriage is returning to its station at the left of the plotter. |
Returning cartridge(s) |
|
|
|
STATUS | The plotter is trimming the edge of roll media. |
Roll feed edge trim |
|
|
|
STATUS | The plotter is doing an internal check during |
Initializing |
|
|
|
STATUS | The plotter has received a file, is ready to print, but has no media loaded. |
Out of media |
|
|
|
STATUS | The plotter is printing. |
Printing |
|
|
|
STATUS | The plotter is printing with a special print mode controlled by your software rather |
Printing (Special) | than by the plotter. |
|
|
STATUS | The plotter is ready for you to load media. |
Ready for media |
|
|
|
STATUS | The plotter is ready to print. |
Ready |
|
|
|
STATUS | The plotter is receiving or has received plot data. |
Receiving |
|
|
|
STATUS | The plotter is testing the cartridge(s) for problems, i.e., clogged cartridge or bad |
Testing cartridge(s) | electrical connection (improper seating). |
|
|
Switch power off | Turn off the plotter. The cartridge carriage cannot move. The plotter may be |
Check cartridge path | jammed with media. Check the media path and clear it if necessary. Then turn on |
| the plotter. |
|
|
Switch power off | Turn off the plotter. The drive roller cannot move or the roll feed spindle cannot |
Check paper path | freely rotate. The plotter may be jammed with media. Check the media path and |
| clear it if necessary. Then turn on the plotter. |
|
|
System error | An internal error has occurred and a system error number is displayed. Press |
XXXXXX | Enter; this may clear the error and allow you to continue. If you cannot continue, |
| turn off the plotter, then turn it on again. If you still see the system error message, |
| record the system error number and have the plotter serviced. For support |
| details, see page |
|
|
Wrong cartridge type | You have loaded one or more incompatible cartridges. Replace the cartridges with |
| those appropriate for this plotter. |
|
|
10 MESSAGES