HP Design Jet Plotter 700, Design Jet Plotter 750C Plus Task 4: Load Media, IMPORTANT, To Load a Roll

Setting Up the Plotter

Task 4: Load Media

	Task 4: Load Media
	For advice on the availability and use of different media types, see the section
	starting on page 3-2.
IMPORTANT	Because the next task is to load the cartridge(s) and carry out the automatic
	cartridge alignment procedure, you must load opaque media at this stage ± for
	example, opaque bond (plotter paper) for the DesignJet 700 or coated paper for the
	DesignJet 750C Plus, as this necessary for the alignment procedure. A roll of
	suitable HP Media is supplied with your plotter.
	To load roll media, start with step 1 below.
	To load sheet media, go to page 1-18.

To Load a Roll

1Make sure the plotter wheels are locked (the brake levers pressed down) to prevent the plotter from moving.

2Open the roll cover and remove the empty spindle by pulling firmly on each end. The two ends are different: end A has a media stop and end B a smaller end cap, as shown on the next page.

B

Roll cover A

Place the spindle vertically on the floor, with the media stop at the bottom, ready for the new roll.

1865

1SETUP

1-11