HP Design Jet Plotter 700, Design Jet Plotter 750C Plus manual End cap removed

Setting Up the Plotter

Task 4: Load Media

3

Remove the new roll from its wrapping. Remove the end cap from the top of the spindle, and slide the new roll onto the spindle. The leading edge of the media must wind clockwise.

End cap removed.

If the media stop falls off, push it back	A
in until it snaps into position.

0015

4

Push the end cap back in, making sure that the tabs are flush against the ends of the roll. Push it far enough to be firm, but do not use excessive force as this may break the tabs.

B

0016

1-12