|
|
|
|
| This is a list of all possible messages in the |
|
| something, it is shown in italics in the Explanation and Action column. |
|
| The messages are listed in alphabetical order. |
|
|
|
Message |
| Explanation and Action |
|
|
|
Alignment error |
| The alignment procedure has failed. Check that an opaque media is loaded. |
Continue | Press ↓ to continue and force the automatic alignment procedure again by | |
|
| reseating any of the print cartridges. Do not lift the window while cartridge |
|
| alignment is being performed. |
|
|
|
Calibrate error |
| The calibration plot was loaded incorrectly and it could not be measured. Press ↓ |
Continue | to continue, then reload the plot for measurement. Follow front panel instructions. | |
|
|
|
Calibration done |
| Accuracy calibration is complete. Press ↓ to continue. |
Continue |
| |
|
|
|
Close roll cover |
| Rewind the media to take up any slack in the roll, close the roll cover, then press |
Continue | ↓ to continue. | |
|
| |
Create pattern | Press ↑ to create the pattern for automatic calibration. | |
Measure pattern | Press ↓ to start the automatic calibration. | |
|
|
|
Edge not found |
| The plotter could not find edge of media during loading procedure. Check the |
Reload media |
| leading edge of the media for unevenness or tears; cut a straight edge, if |
|
| necessary, and reload. Be sure to position the right edge along the perforated line |
|
| on the entry platen when loading. |
|
|
|
Lift lever |
| Lift the lever at the right of the plotter. |
|
|
|
Load arrow edge |
| Remove calibration plot, turn it so that the edge with arrows printed on it is print |
print side down |
| side down, then load that edge into the plotter. |
|
|
|
Load cancelled |
| You pressed the Cancel button while media loading was in progress. Remove |
Remove media |
| media. |
|
|
|
Load error |
| You inserted media with the media lever raised. Lower the lever and reload the |
Remove media |
| media. |
|
|
|
Load media |
| Load media to proceed with cartridge alignment. |
to align cartridges |
|
|
|
|
|
Lower lever |
| When you have finished aligning the roll media as instructed, lower the lever at |
after aligning |
| the right of the plotter. |
|
|
|