Troubleshooting

Chapter 12

3.Lightly press down on the print cartridge to release it, and then pull it toward you out of the slot.

NOTE: Do not remove both print cartridges at the same time. Remove and clean each print cartridge one at a time. Do not leave a print cartridge outside the HP All- in-One for more than 30 minutes.

4.Inspect the print cartridge contacts for ink and debris buildup.

5.Dip a clean foam rubber swab or lint-free cloth into distilled water, and squeeze any excess water from it.

6.Hold the print cartridge by its sides.

7.Clean only the copper-colored contacts. Allow the print cartridges to dry for approximately ten minutes before reinserting.

1Copper-colored contacts

2Ink nozzles (do not clean)

8.Slide the print cartridge back into the slot. Push the print cartridge forward until it clicks into place.

9.Repeat if necessary for the other print cartridge.

10.Gently close the print cartridge door and plug the power cord into the back of the HP All-in-One.

90 Troubleshooting

Page 92
Image 92
HP F2140, F2187, F2180, F2120, F2110 manual Troubleshooting