Changing settings

The item-count value is changed using a different method from that used for other control-panel values. Instead of increasing the entire value by increments, each digit can be selected and modified individually. The following control-panel buttons are used to modify the page count value:

SELECT Enters any changes to the current digit and advances the cursor one digit to the right. If the last digit is currently selected, pressing SELECT wraps the cursor around to the 2 first digit.

VALUE + Increases the value of the currently selected digit by one. Pressing VALUE+ when 9 is the value of the currently selected digit changes the value of the digit to 0.

–VALUEDecreases the value of the currently selected digit by one. Pressing –VALUEwhen 0 is the value of the currently selected digit changes the value of the digit to 9.

Page count

The page count that is stored in NVRAM and is shown on the configuration page printout represents the number of pages the printer has printed (excluding engine-test prints). If it is necessary to install a new formatter in the printer, the page count must be reset so that it represents the age of the printer engine rather than the age of the formatter.

Note

Before replacing the formatter or firmware DIMM, print a configuration page and a menu map to verify the current printer settings. Use the information on these pages to reset the customer’s print settings.

Changing the page count (example)

EN

LJ 4100 Service mode functions 121