Resetting the printer
Cold reset/EIO card reset
Note
This feature sets all system parameters to the factory defaults.
To perform a cold reset:
1Turn the printer off.
2Press and hold GO.
3Turn the printer back on, and continue to hold GO until the Attention light turns on.
4Release GO.
The device lights begin cycling from front to rear. The
NVRAM initialization
This feature re initializes NVRAM and sets all system parameters to the factory defaults. During the NVRAM initialization process, all button presses are ignored.
To perform an NVRAM initialization:
1Turn the printer off.
2Press and hold GO.
3Turn the printer back on, and continue to hold GO until the Attention, Ready, and Go lights turn on.
4Release GO.
The device lights begin cycling from front to rear. The NVRAM initialization runs until completion, when the device is in the Ready state.
96 Chapter 2 – Service mode | EN |