68.x Permanent storage full
The printer permanent storage is full. Some settings might have been reset to the factory defaults.
1Print a configuration page, and then check the printer settings to determine which values have changed.
2Hold down CANCEL JOB while turning the printer on. This will clean up the NVRAM by removing old areas that are not being used.
69.x Printer error alternates with Cycle power to continue
X = Description
0 = The duplex mechanism has failed.
1Turn the printer off, and then turn the printer back on.
2Reseat the duplexer.
3Replace the duplexer.
79 Service (####)
3200 series only
1Disconnect the power cable from the product, wait at least 30 seconds, reconnect the power cable, and then wait for the product to initialize.
2If the error persists, replace the DIMMs.
3If the error still persists, replace the formatter.
82 Chapter 1 – | EN |