Phone number error
The maximum number of characters that can be used is 60. If you have
a number longer than 60 characters, break the number into smaller 1 chunks.
1Type the first part of the number, and then press REDIAL/PAUSE as the last character in the first number.
2Type the second part of the number as if it were a second number going to a group. When the product dials, it will treat both numbers as if they are one.
Make sure that the sender’s fax machine is ready to be polled, and check the fax number. Then, set up to poll again.
Power fail recover/Checking system
The product has detected a power failure and is performing a
1The product should go back to the Ready state on its own. If this message does not disappear in a couple of minutes, disconnect the power cable from the product, wait at least 30 seconds, and then reconnect the power cable.
2Wait for the product to initialize.
Power fail recovery/Fax setting reset
Press STOP/CLEAR to clear the error. The product should return to the Ready state.
Power fail recovery/Printing faxes
The product has detected a power failure and is printing all of the faxes that it did not previously print. Once the faxes are printed, the product returns to the Ready state.
EN | Alphabetical messages 55 |